Modbus and HTTP TCP / IP communication protocols for user applications (customised software)
Modbus TCP / IP communication protocol:
Modbus is a communication protocol located at layer 7 of the OSI Model, based on the master / slave o client / server architecture designed in 1979 by Modicon for its range of programmable logic controllers (PLCs). It has become a “de facto” standard within the industrial manufacturing environment and is the most widely used for the connection of industrial electronic devices. The Modbus TCP / IP protocol transmits via Ethernet port 502.
For further information, consult the specifications and guidelines at “The Modbus Organization” website: http://www.modbus.org/.
- Modbus messaging on TCP / IP implementation guide V1.0b.
- Modbus application protocol specification V1.1b3.
Modbus supported commands:
Read Coils / Reading of digital outputs status
Read Input Registers / Reading of a register
Write Single Coil / Writing of the status of a digital output
Write Single Register / Writing of a register
Digital outputs (relays)
Commands: 01 and 05
Read / write
General measurements and values
Reset and reset to zero command
TCP / IP communication protocol. HTTP. WebServer
There are multiple TCP / IP commands which can be sent to a remote unit from the address bar of any browser or through a software programme customized to the user’s requirements. These commands must be sent to the IP address and port of the remote unit and, in order to be effective, must include the user’s PIN as configured in the remote unit of destination.
1. Receive the complete measurement list in .txt format
2. Counter reset to zero command and reset of maximum measurements
3. Enable/disable internal relays RA, RB, RC, RD, RE and RF.